:	Oct 13, 2004

: Make sure the ignition switch is in position 0.

.

Remove the cover.

.

Disconnect the electrical connector.

.

: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.   : Before the disconnection or removal of any components, ensure the area around joint faces and connections are clean. Plug any open connections to prevent contamination. Disconnect the 6 brake tubes.   Position an absorbent cloth to collect fluid spillage.

.

Remove the ABS module from the mounting bracket.   Loosen, but do not remove, the 2 nuts securing the ABS module to the bracket.

.

:   Make sure the ABS module locating grommet is correctly seated in the bracket before installing the ABS module. :   Make sure the ABS module locating pin is correcly located in the grommet, and the 2 front isolators are fully seated in the bracket slots. Install the ABS module.   Tighten the 2 ABS module retaining nuts to 8 Nm (6 lb.ft).   Remove the blanking caps from the ports.   Tighten the two M10 and three M12 brake tube unions to 15 Nm (11 lb.ft).   Tighten the M14 brake tube union to 17 Nm (13 lb.ft).   Connect the electrical connector.   Remove the ABS module from the mounting bracket.

.

Using T4, bleed the braking system.

.

Install the cover.

.

If a new ABS module has been installed, interrogate the ABS system using T4.